Once the panel is removed, the ribbon cable can be disconnected and cleaned with a pencil eraser or by purchasing an electrical cleaner. To access the ribbon cable, the panel covering the control board at the back of the oven needs to be removed. The ribbon cable connects the key panel with the control board. Occasionally, the F7 error code is caused by a loose or dirty ribbon cable. JGBS22BEW3WH Check & Clean the Ribbon Cable This guide applies to the following models: The cause of the issue needs to be diagnosed and fixed to stop the error code from reappearing. An issue with the oven’s clock may also be responsible, which, on most models, will require that the control board be replaced.įor a temporary solution to the problem, the oven can be reset either by disconnecting the power to the oven for three minutes or by resetting the oven through the key panel (check the oven’s manual for reset instructions). In most cases, the issue can be resolved by cleaning the ribbon cable, replacing the key panel, or replacing the control panel. Often the issue is that the oven is detecting that buttons are stuck or being pressed down at the same time. If your GE oven is showing an F7 error code, it means that there is an issue with the key panel.
0 kommentar(er)
